Debugging method 1. Start to adjust the feeding mechanism of the disk, put in the sample, and adjust the height of the arranging rod so that it can block the sample without rubbing the surface of the turntable. 2. In the docking conveying mechanism (1) First connect with the feeding mechanism and conveying of the tray. (2) Put the sample in, adjust the guardrails at both ends, and then adjust the spacing between the two sides of the outlet and the upper limit sheet metal. The sample can pass normally, but it can be stuck at the exit (can be hooked out by the conveying jig). (3) Adjust the position of the electric eye, the electric eye at the upper end of the outlet should be adjusted to the out point, so that the docking conveying can always be opened, so that the samples can be hooked out by the fixture one by one.